Filter
Top Products
1
perfSetPortEEMask
1-301
Telnet Commands
Operands This command has the following operands:
slotnumber
Specify the slot number in an ED-12000B
switch. The slot number must be followed by a
slash ( / ) and the port number.
The ED-12000B has a total of 10 slots counted
from 1 to 10. Slot number 5 and 6 are control
processor cards, and slot 1 through 4 and 7
through 10 are switch cards. On each switch
card, there are 16 ports counted from the
bottom 0 to 15. A particular port must be
represented by both slot number (1 through 4
or 7 through 10) and port number (0 through
15).
This operand is not required for switches that
do not have blades.
portnumber
Specify a port number. Valid values for port
numbers vary depending on the switch type.
This operand is required.
TxSIDMsk
Specify the source ID mask in dd:aa:pp format,
where dd is Domain ID mask, aa is Area ID
mask and pp is ALPA ID mask. For example,
00:ff:00 uses TxSID Area ID to trigger EE
monitor comparison.
Specify the following values to turn on or off a
specific field:
00 - Specifies that the field does not trigger EE
monitors.
ff - Specifies that the field triggers EE monitors.
This operand must be enclosed in quotation
marks. This operand is required.