1
1-166
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
Operands This command has the following operands:
-s
Specify this option to enable Single CP Mode. This
option is available in v4.0 only. In the ED-12000B, by
default,
firmwareDownload will upgrade both CPs.
This mode enables the users to upgrade a single CP
in the switch. In the DS-32B2, this mode has no
effect.
-b
Specify this operand to activate auto-reboot mode.
This operand is only available in v4.0. After
downloading firmware the system must be
rebooted. If this operand is not specified, the user
must issue the
reboot command manually in order
to activate the downloaded image. If Auto-reboot
mode is enabled, the switch reboots automatically
after the
firmwareDownload command has been
run.
-n
Specify this operand to de-activate auto-commit
mode. This operand is only available in v4.0. By
default, after running this command and after
reboot, the switch will perform a firmwareCommit
command automatically. When this mode is
disabled, the user needs to issue the
firmwareCommit command manually to replicate
the downloaded image from the primary partition
to the secondary partition of a CP.
-i
Specify this operand to enable Incremental Install
Mode. By default,
firmwareDownload will do a full
install of the whole firmware regardless of what the
original firmware version was on the system. In
Incremental Install Upgrade Mode the names of
packages in pfile are compared to what already
installed on the switch and only the packages which
are different from those already stored or not on the
switch yet are installed.
host
Specify a host name or IP address in quotation
marks; for example, "
citadel" or "192.168.1.48".
The configuration file is downloaded from this host
system. If this operand is not used, the pfile is
considered to be accessable through a local
directory. This operand is required.