1
switchStatusPolicySet
1-447
Telnet Commands
Example Notice that in the following example, the only parameters modified
are the number of Missing SFPs allowed before the status of the
switch changes to MARGINAL and DOWN
.
switch:admin> switchStatusPolicySet
To change the overall switch status policy parameters
The current overall switch status policy parameters:
Down Marginal
----------------------------------
FaultyPorts 1 0
MissingGBICs 0 1
PowerSupplies 2 1
Temperatures 2 1
Fans 2 1
PortStatus 0 0
ISLStatus 2 1
Note that the value, 0, for a parameter, means that it is
NOT used in the calculation.
** In addition, if the range of settable values in the prompt is (0..0),
** the policy parameter is NOT applicable to the switch.
** Simply hit the Return key.
The minimum number of
FaultyPorts contributing to DOWN status: (0..64) [2]
FaultyPorts contributing to MARGINAL status: (0..64) [1]
MissingGBICs contributing to DOWN status: (0..64) [0]
MissingGBICs contributing to MARGINAL status: (0..64) [0] 1
Bad PowerSupplies contributing to DOWN status: (0..4) [2]
Bad PowerSupplies contributing to MARGINAL status: (0..4) [1]
Bad Temperatures contributing to DOWN status: (0..8) [2]
Bad Temperatures contributing to MARGINAL status: (0..8) [1]
Bad Fans contributing to DOWN status: (0..3) [2]
Bad Fans contributing to MARGINAL status: (0..3) [1]
Down PortStatus contributing to DOWN status: (0..8) [0]
Down PortStatus contributing to MARGINAL status: (0..64) [0]
Down ISLStatus contributing to DOWN status: (0..64) [2]
Down ISLStatus contributing to MARGINAL status: (0..64) [1]
Policy parameter set has been changed
See Also switchStatusPolicyShow
switchStatusShow