Filter
Top Products
1
1-126
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
diagshowtime
Enable or disable elapsed time messages.
Syntax
diagshowtime [mode | -show]
Availability Admin
Description Use this command to enable or disable show time mode. The mode is
saved in nonvolatile memory and stays in that mode until the next
execution of
diagshowtime.
The mode becomes active as soon as this command is executed. It
does not require a reboot to take effect.
Show time mode when enabled causes each test to display elapsed
time messages. It is normally used during burn-in and for test
method debug.
Operands This command has the following operands:
If no operand is specified the current value is displayed.
Example
To enable show time mode:
switch:admin> diagshowtime
Show Time mode is 0 (Disabled).
switch:admin> diagshowtime 1
Config update Succeeded
Show Time mode is now 1 (Enabled).
switch:admin>
See Also diagHelp
mode
Specify 1 to enable show time mode, specify 0
to disable show time mode. This operand is
optional.
-show
Specify this operand to display the current
mode setting. This operand is optional.