Filter
Top Products
1
linkCost
1-233
Telnet Commands
Operands This command has the following operands:.
If no operands are specified, the current values for all ports on the
switch are displayed.
slotnumber
Specify the slot number in an ED-12000B switch.
The slot number must be followed by a slash ( / )
and the port number. This operand is optional.
The ED-12000B has a total of 10 slots counted
from 1 to 10. Slot number 5 and 6 are control
processor cards, and slot 1 through 4 and 7
through 10 are switch cards. On each switch card,
there are 16 ports counted from the bottom 0 to
15. A particular port must be represented by both
slot number (1 through 4 or 7 through 10) and
port number (0 through 15).
This operand is not required for switches that do
not have blades.
portnumber
Specify the port number to display or set the
FSPF cost of a link. Valid values for port number
vary depending on the switch type. This operand
is optional.
cost
Specify the new cost of the link connected to the
specified port number. This operand is optional.