Filter
Top Products
1
1-328
EMC Connectrix DS-32B2 and ED-12000B Fabric OS Reference Manual
Telnet Commands
portCfgTrunkport
Configure a port to be enabled or disabled for trunking.
Syntax
portCfgTrunkport [slotnumber/]portnumber, mode
Availability Admin
Description Use this command to configure a port to be enabled or disabled for
trunking.
This command requires a Trunking license.
Operands This command has the following operands:
slotnumber
Specify the slot number in an ED-12000B switch.
The slot number must be followed by a slash ( / )
and the port number.
The ED-12000B has a total of 10 slots counted from
1 to 10. Slot number 5 and 6 are control processor
cards, and slot 1 through 4 and 7 through 10 are
switch cards. On each switch card, there are 16
ports counted from the bottom 0 to 15. A particular
port must be represented by both slot number (1
through 4 or 7 through 10) and port number (0
through 15).
This operand is not required for switches that do
not have blades.
portnumber
Specify the port number where you want to enable
or disable trunking. Valid values for port number
vary depending on the switch type. This operand is
required.
mode
Specify 1 to enable this port for trunking. Specify 0
to disable this port for trunking. This operand is
required.