Filter
Top Products
Network Installation ColorQube™ 9201/9202/9203
5-4 System Administrator Guide
Enable Dynamic DNS Registration
Note
If your DNS server does not support dynamic updates, then this function does not need to be enabled.
38. Touch [Dynamic DNS Registration].
39. Click on [Enable], then [Save].
40. Touch [Close] three times.
41. Press the [Log In/Out] button, touch [Logout] to exit Tools mode.
Configure Dynamic Addressing
Information Checklist
Before starting the installation procedure, please ensure that the following items are available and/or the
tasks have been performed:
• Existing operational network utilizing the TCP/IP protocol.
• DHCP or BOOTP Server should be available on the network.
• Device must be connected to the network via Ethernet Cable.
Installation via DHCP (Dynamic Host Configuration Protocol)
DHCP is enabled on the device by default. If the device is connected to the network, the TCP/IP information
will be configured when the device is powered on and no further configuration is required.
Print a Configuration Report to verify that TCP/IP information is correct.
1. Press the <Machine Status> button on the device.
2. Touch the [Machine Information] tab.
3. Touch [Information Pages].
4. Touch [Configuration Report].
5. Touch [Print], then touch [Close].
The Confirmation Report is printed, verify the TCP/IP information.
Installation via BOOTP or DHCP
Ensure your device is connected to the network with Ethernet cabling.
1. Go to the device and press the <Log In/Out> button to enter the Tools pathway.
2. Enter the Administrator’s User Name [admin], touch [Next], enter Password [1111], touch [Enter].
3. Press the <Machine Status> button, and then the [Tools] tab.
4. Touch [Network Settings].
5. Touch [TCP/IP Settings].
6. Touch [Dynamic Addressing]. By default, DHCP is selected.
7. Select the required Dynamic Addressing method:
• [BOOTP]
• [DHCP]
8. Touch [Save].
9. Touch [Close].