Filter
Top Products
100 System Management Commands
snmp-server enable traps linkmode
Mode
Global Config
Command
History
Related
Commands
snmp-server enable traps linkmode
This command enables Link Up/Down traps for the entire switch. When enabled, link traps
are sent only if the Link Trap flag setting associated with the port is enabled (see ‘snmp trap
link-status’ command).
Syntax
[no] snmp-server enable traps linkmode
The no version of this command disables Link Up/Down traps for the entire switch.
Default
enabled
Mode
Global Config
snmp-server enable traps multiusers
This command enables Multiple User traps. When the traps are enabled, a Multiple User Trap
is sent when a user logs in to the terminal interface (EIA 232 or telnet) and there is an existing
terminal interface session.
Syntax
[no] snmp-server enable traps multiusers
The no version of this command disables Multiple User traps.
Default
enabled
Mode
Global Config
Version 2.3 Introduced
Note: The CLI indicates successful execution of this command, and the show
trapflags report shows successful execution of the command, but this trap is not
currently supported.
storm-control broadcast Enable broadcast storm recovery mode.
show storm-control
Display switch configuration information.