Filter
Top Products
terminal length
SFTOS Command Reference for the S2410, Version 2.4.1.0 145
terminal length
Configure the number of lines to be displayed on the terminal screen in one page of output of
“show” commands.
Syntax
terminal length number-of-lines
Defaults
24 lines
Mode
Use Exec or Privileged Exec
Command
History
Usage
Information
This is a session-based command. The CLI presents 24 lines per page of “show” command
output, as a default, unless the user uses this command to change the number of lines. At the
end of each page, the user can press q for quit—to stop the output and return to the command
line—or any other key to see the next page of the display.
traceroute
This command is used to discover the routes that packets actually take when traveling to their
destination through the network on a hop-by-hop basis.
Syntax
traceroute ipaddr [port]
ipaddr
should be a valid IP address.
The optional
port parameter is the UDP port used as the destination of packets sent as part of
the traceroute. This port should be an unused port on the destination system. It should be a
valid decimal integer in the range of 0 (zero) to 65535. The default value is 33434.
Mode
Privileged Exec
Parameters
number-of-lines
Enter the number of lines that you want the output to display before pausing.
Entering zero (0) will cause the terminal to display without pausing.
Range: 0|5 to 512. (1-4 cannot be set.)
Default: 24 lines.
Version 2.3 Introduced
Related
Commands
show terminal length
Displays the number of lines set by
terminal length.
show tech-support
Use show tech-support non-paged for uninterrupted output.