Filter
Top Products
show storm-control
SFTOS Command Reference for the S2410, Version 2.4.1.0 199
Broadcast Storm Control Commands
This section contains the following commands:
• show storm-control
• storm-control broadcast on page 200
• storm-control flowcontrol on page 200
show storm-control
This command displays switch configuration information.
Syntax
show storm-control [unit/slot/port | all]
Mode
Privileged Exec
Broadcast Storm Recovery Mode—May be enabled or disabled. The factory default is disabled.
802.3x Flow Control Mode—May be enabled or disabled. The factory default is disabled.
Example
Figure 46 Command Example: show storm-control
Note: This feature works on the 10G ports of the S2410, but because of S2410
hardware limitations, broadcast storm recovery counters are not incremented.
Force10-S50 #show storm-control
802.3x Flow Control Mode....................... Disable
Force10-S50 #show storm-control 1/0/1
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
Force10-S50 #show storm-control all ?
<cr> Press enter to execute the command.
Force10-S50 #show storm-control all
Bcast Bcast Mcast Mcast Ucast Ucast
Intf Mode Level Mode Level Mode Level
------ ------- ------- ------- ------- ------- -------
1/0/1 Disable 5 Disable 5 Disable 5
1/0/2 Disable 5 Disable 5 Disable 5
1/0/3 Disable 5 Disable 5 Disable 5
1/0/4 Disable 5 Disable 5 Disable 5
1/0/5 Disable 5 Disable 5 Disable 5
1/0/6 Disable 5 Disable 5 Disable 5
1/0/7 Disable 5 Disable 5 Disable 5
1/0/8 Disable 5 Disable 5 Disable 5
1/0/9 Disable 5 Disable 5 Disable 5
!-----------output truncated---------------!