Filter
Top Products
4 New Features
• The maximum number of LAGs is 12, with a maximum of 12 ports in a LAG (vs. 32
LAGs, with a maximum of eight members each in SFTOS 2.3.1). See Chapter 15, LAG/
Port Channel Commands, on page 249.
• Maximum Jumbo Frame size increased from 9216 to 10240.
• IGMP Snooping: The current S2410 hardware does not support IGMP Snooping, so the
commands in the IGMP Snooping chapter appear in the CLI but do not function.
• ACLs, CoS, and QoS:
— IP ACLs are not available.
— The CoS traffic class range is four. See the commands using the
trafficclass
parameter in Chapter 17, Quality of Service (QoS) Commands, on page 275.
— QoS DiffServ is not supported.
—The
ip_dscp parameter of the classofservice trust command is not supported.
See classofservice trust on page 277.
— Maximum number of ACLs increased from 100 to 1024.
— Maximum MAC ACL rules per ACL increased from 8 to 64.
— Only MAC ACLs with a source MAC are supported (cannot configure with a
destination MAC)
Deprecated Commands
In SFTOS 2.4.1, the following VLAN commands, in the Global Config and Interface Config
modes, exist in the CLI but are deprecated (They appear in the CLI, but do not work correctly
in some situations, and will be removed in the next release.):
•
vlan acceptframe
• vlan ingressfilter
• vlan participation all
• vlan port acceptframe
• vlan port ingressfilter all
• vlan port pvid all
• vlan port tagging all
• vlan port untagging all
• vlan pvid
• vlan tagging
• vlan untagging
•[no] port lacpmode enable (Interface Config mode) and [no] port lacpmode
enable all
(Global Config mode): These commands create configuration elements that
do not survive a reload. Instead, use [
no] port channel staticcapability (Global
Config mode). See port-channel staticcapability on page 253.
Note: To configure VLANs, use the interface vlan command (Global Config mode) to access
the commands in VLAN mode. See
Virtual LAN (VLAN) Commands on page 120.