Filter
Top Products
60 System Management Commands
management route default
Default
None
Mode
Interface ManagementEthernet
Command
History
Related
Commands
management route default
This command sets the IP gateway of the switch. The management IP address (configured
with the
ip address, above) and the gateway must be on the same subnet.
Syntax
management route default gateway
Parameters
Use no management route default to remove the gateway.
Mode
Global Config
Command
History
Usage
Information
Use this command along with the ip address command to configure the management
address of the switch. Execute the interface managementethernet command from Global
Config mode to access the
ip address command, as shown in the following example.
Version 2.3
Introduced. Replaces the network mac-type
command.
interface managementethernet Invokes the Interface ManagementEthernet mode, the
(Config-if-ma)# prompt.
gateway
Valid IP address
Version 2.3 Introduced: Replaces the network parms command for the gateway part of the
management address.
Note: The IP Address and the gateway must be on the same subnet.