Filter
Top Products
protocol
SFTOS Command Reference for the S2410, Version 2.4.1.0 63
protocol
This command specifies the network configuration protocol to be used for the management
VLAN.
Syntax
protocol {none | bootp | dhcp}
If you modify this value, the change is effective immediately. The bootp keyword indicates
that the switch periodically sends requests to a Bootstrap Protocol (BootP) server or a DHCP
server until a response is received. The
none keyword indicates that the switch should be
manually configured with IP information.
Default
none
Mode
Interface ManagementEthernet
Command
History
Related
Commands
serviceport ip
This command configures the IP address of the Ethernet Management port (service port).
Syntax
serviceport ip ipaddr netmask [gateway]
For
ipaddr, designate an IP address of the Ethernet Management port. This is the IP address
that you would enter in your Web browser to access that port through the SFTOS Web User
Interface. The default is 0.0.0.0.
For
netmask, designate a 4-digit dotted-decimal number that represents the subnet mask of
the Ethernet Management port IP address.
The value for
gateway is the gateway IP address to the Ethernet Management port IP
address. The default is 0.0.0.0.
Enter
no serviceport ip address to remove the IP address configuration.
Mode
Global Config mode
Command
History
Version 2.3
Introduced. Replaces the network protocol command.
management route default Sets the IP gateway of the switch.
interface managementethernet Invokes the (Config-if-ma)# prompt.
Version 2.4.1 Introduced