Filter
Top Products
80 System Management Commands
show msglog
Static—The value of the corresponding instance was added by the system or a user when a static
MAC filter was defined. It cannot be relearned.
Learned—The value of the corresponding instance was learned by observing the source MAC
addresses of incoming traffic, and is currently in use.
Management—The value of the corresponding instance (system MAC address) is also the value
of an existing instance of dot1dStaticAddress. It is identified with interface 0/1 and is currently used
when enabling VLANs for routing.
GMRP Learned—The value of the corresponding was learned via GMRP and applies to Multicast.
Other—The value of the corresponding instance does not fall into one of the other categories.
Example 2
Figure 14 Example of Output from the show mac-addr-table count Command
Example 3
Figure 15 Example of Output from the show mac-addr-table vlan Command
Related
Commands
show msglog
Command
History
Related
Commands
Force10 #show mac-addr-table count
Dynamic Address count.......................... 0
Static Address (User-defined) count............ 0
Total MAC Addresses in use..................... 0
Total MAC Addresses available.................. 16384
(S50-TAC-8) #show mac-addr-table vlan 1
Mac Address Interface Status
----------------- --------- ------------
00:01:E8:D5:A2:19 3/1 Management
show mac-address-table Depending on selected display parameters, displays various Multicast
Forwarding Database (MFDB) information, including GMRP or IGMP
Snooping entries in the table.
Version 2.3
Deprecated: The keyword
traplogs in the command show logging provides the
information that had been available through this command.
show logging traplogs Displays the SNMP trap log maintained by the switch.
show logging Displays a combination of the system log and event log (buffered log).
show logging buffered Displays buffered logging (the System log)
show logging hosts Displays configured logging hosts (syslog servers.