Filter
Top Products
enable
SFTOS Command Reference for the S2410, Version 2.4.1.0 107
Syntax
configure
Command Modes
Privileged Exec
Usage
Information
Users executing this command enter the Global Config mode, which provides access to many
commands within that mode. Also, this mode is a gateway to all other more protocol-specific
modes except the VLAN mode.
For details on modes, see Chapter 3, Using the Command Line Interface, on page 39.
Example
Figure 19 configure Command Example
enable
This command accesses the Privileged Exec mode from the User Exec mode. If the enable
password is set, you must enter the password to gain access to the Privileged Exec mode.
Syntax
enable
Defaults
none
Mode
User Exec
Usage
Information
Users who execute this command enter the Privileged Exec mode, gaining access to the
commands available in this mode, as well as being able to directly access the Global Config
mode and the VLAN mode. After accessing the Global Config mode, users can access all
modes to which the Global Config mode provides a gateway.
To protect against unauthorized access, use the command enable passwd to configure a
password for the command.
Example
Figure 20 enable Command Example
(S50) #configure
(S50) (Config)#
Related
Commands
enable The enable command accesses the Privileged Exec mode.
Note: In a stack, only the management unit (stack manager) provides access to CLI
commands. Other member units display the prompt “(Unit [unit number])”.
(S50)>enable
Password:
(S50)#