Filter
Top Products
218 SNTP Commands
sntp server
Default
1 retry
Mode
Global Config
sntp server
This command configures an SNTP server connection (with a maximum of three).
Syntax
sntp server ipaddress [priority [version [portid]]]
Use the no sntp server remove ipaddress command to delete the server from the list of
SNTP servers.
Mode
Global Config
show sntp
This command is used to display SNTP settings and status.
Syntax
show sntp
Mode
Privileged Exec
Example
Figure 47 show sntp Command Example
Parameters
ipaddress
Specify either the IPv4 address of the server or a DNS hostname. If DNS, then that
hostname should be resolved into an IP address each time a SNTP request is sent
to it.
priority
Optionally, specify the priority of this server entry in determining the sequence of
servers to which SNTP requests will be sent. The client continues sending
requests to different servers until a successful response is received or all servers
are exhausted. A server entry with a priority of 1 is queried before a server with a
priority of 2, and then a server with a priority of 3. If more than one server has the
same priority then the requesting order follows the lexicographical ordering of the
entries in this table. Allowed range is 1 to 3. Default value is 1.
version If priority is specified, optionally identify the NTP version running on the server.
Allowed range is (1 to 4). Default value is 4.
portid
The the port ID a value of 1–65535.
Force10# show sntp
Last Update Time: AUG 20 09:04:15 2006
Last Unicast Attempt Time: AUG 20 09:04:15 2006
Last Attempt Status: Success
Broadcast Count: 0
Force10#