Filter
Top Products
monitor session 1 mode
SFTOS Command Reference for the S2410, Version 2.4.1.0 113
monitor session 1 mode
This command sets the monitor session (port monitoring) mode to enabled. The probe and
monitored ports must be configured before port monitoring can be enabled. When enabled,
the probe port monitors all traffic received and transmitted on the physical monitored port. It
is not necessary to disable port monitoring before modifying the probe and monitored ports.
A session is operationally active if and only if both a destination port and at least one source
port is configured. If neither is true, the session is inactive.
A port configured as a destination port acts as a mirroring port when the session is
operationally active. If it is not, the port acts as a normal port and participates in all normal
operation with respect to transmitting traffic.
Syntax
[no] monitor session 1 mode
The no version of this command sets the monitor session (port monitoring) mode to disabled.
Default
disabled
Mode
Global Config
no monitor
This command removes all the source ports and a destination port and restores the default
value for mirroring session mode for all the configured sessions.
This is a stand-alone “
no” command. This command does not have a “normal” form.
Default
enabled
Syntax
no monitor
Mode
Global Config
Related
Commands
monitor session Adds a mirrored port (source port) or mirroring port (destination
port) to a session identified with the session ID of 1.
no monitor Removes the destination port and all source ports from the mirroring
configuration.
show monitor session Shows the mirroring configuration.