Filter
Top Products
180 Security Commands
users defaultlogin
users defaultlogin
This command assigns the authentication login list to use for non-configured users when
attempting to log in to the system. This setting is overridden by the authentication login list
assigned to a specific user if the user is configured locally. If this value is not configured,
users will be authenticated using local authentication only.
Syntax
users defaultlogin listname
Mode
Global Config
users login
This command assigns the specified authentication login list to the specified user for system
login. The
user must be a configured user and the listname must be a configured login list.
If the user is assigned a login list that requires remote authentication, all user access (from all
CLI, Web, and Telnet sessions) will be blocked until authentication is complete.
Note that the login list associated with the ‘admin’ user cannot be changed to prevent
accidental lockout from the switch.
Syntax
users login user listname
Mode
Global Config
RADIUS Commands
This section contains the following commands for the Remote Authentication Dial-In User
Service (RADIUS), one method for validating administration access to the switch:
• radius accounting mode on page 181
• radius server host on page 181
• radius server key on page 182
• radius server msgauth on page 183
• radius server primary on page 183
• radius server retransmit on page 183
• radius server timeout on page 184
• show radius on page 184
• show radius accounting statistics on page 185
• show radius statistics (authentication) on page 186