Filter
Top Products
SFTOS Command Reference for the S2410, Version 2.4.1.0 35
Management IP Address
In addition to logging into the CLI to view and manage network parameters, you can use the
following methods:
• Simple Network Management Protocol (SNMP)
• SSH
• Telnet
• SFTOS Web User Interface (Web UI) through a Web browser (See Using the Web User
Interface on page 51.)
Each of these methods require that you first use the CLI through the console port to configure
a management IP address, subnet mask, and default gateway. The S2410 actually provides the
ability to configure two management IP addresses:
• An IP address that accesses the Ethernet Management port, an RJ-45/Ethernet port
dedicated to managing the switch: See Configuring the Ethernet Management Port on
page 36).
• An IP address that accesses the management VLAN running on a configurable set of the
other physical ports. See the following procedure.
Note: Keywords and parameters that are shown within braces in syntax statements
must be entered in the CLI. Keywords and parameters that are shown separated by a
bar in syntax statements require you to choose one. Parameters in italics are variables
for which you substitute a value. see Command Syntax Conventions on page 39.
Helpful Hint: After configuring the network parameters, execute write memory so that the
configuration changes are not lost.
Alternatively, you can execute copy system:running-config nvram:startup-config (if
you love to type).