Filter
Top Products
telnetcon maxsessions
SFTOS Command Reference for the S2410, Version 2.4.1.0 91
telnetcon maxsessions
Command
History
Serial Commands
This section describes the following SFTOS system management commands pertaining to
console port connections (serial connections, EIA-232):
• lineconfig on page 91
• serial baudrate on page 91
• serial timeout on page 92
• show serial on page 92
lineconfig
This command accesses the Line Config mode from the Global Config mode.
Syntax
lineconfig
Mode
Global Config
Usage
Information
Users executing this command enter the Line Config mode.
For details on modes, see Chapter 3, Using the Command Line Interface, on page 39.
Example
Figure 18 lineconfig Command Example
Related
Commands
serial baudrate
This command specifies the communication rate of the terminal interface. The supported
rates are 1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Syntax
serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200}
Version 2.3 Modified: Changed to ip telnet maxsessions
(S50) #configure
(S50) (Config)#lineconfig
(S50) (Line)#
configure Accesses the Global Config mode, which is the mode in which you can
execute this
lineconfig command.