Filter
Top Products
102 System Management Commands
snmptrap
Command
History
snmptrap
This command adds an SNMP trap receiver name and trap receiver IP address. The maximum
name length is 16 case-sensitive alphanumeric characters.
Syntax
[no] snmptrap name ipaddr
The no version of this command deletes the specified trap receiver from the community.
Mode
Global Config
snmptrap ipaddr
This command assigns an IP address to a specified community name. The maximum name
length is 16 case-sensitive alphanumeric characters.
Syntax
snmptrap ipaddr name ipaddrold ipaddrnew
Mode
Global Config
snmptrap mode
This command activates or deactivates an SNMP trap. Enabled trap receivers are active (able
to receive traps). Disabled trap receivers are inactive (not able to receive traps).
Syntax
[no] snmptrap mode name ipaddr
The no version of this command deactivates an SNMP trap. Disabled trap receivers are
inactive (not able to receive traps).
Mode
Global Config
Version 2.3
Corrected from
snmp-server enable traps
Note: IP addresses in the SNMP trap receiver table must be unique. If you make
multiple entries using the same IP address, the first entry is retained and processed.
All duplicate entries are ignored.