Filter
Top Products
logging console
SFTOS Command Reference for the S2410, Version 2.4.1.0 151
logging console
This command enables logging of System log messages to the console.
Syntax
logging console [severitylevel]
The severitylevel value is specified through one of the following keywords or the keyword’s
representative integer, as shown here: emergency (0), alert (1), critical (2), error (3), warning
(4), notice (5), informational (6), debug (7). Note that the severity level set here does not
change the severity level set for the System log messages saved in RAM.
Use
no logging console to disable logging to the console.
Default
disabled; severity = critical
Mode
Global Config
logging host
This command configures mirroring of System log messages to a syslog server. Up to eight
server hosts can be configured. Also, use this command to modify the port or logging severity
level to a configured host identified by its IP address.
Syntax
logging host ipaddress [port [severitylevel]]
The
severitylevel value is specified as either an integer from 0 to 7 or symbolically through
one of the following keywords: emergency (0), alert (1), critical (2), error (3), warning (4),
notice (5), informational (6), debug (7). Note that the severity level set here does not change
the severity level set for the System log messages saved in RAM.
Default
Port = 514; Level = critical
Mode
Global Config
Related
Commands
logging buffered Enables logging of the System Log to RAM and any other
enabled destination, including the console and any
enabled syslog server.
show logging hosts