Filter
Top Products
226 GARP, GVRP, and GMRP Commands
set garp timer leave
This command has an effect only when GVRP is enabled. The time is from 10 to 100
(centiseconds). the value 20 centiseconds is 0.2 seconds.
Syntax
set garp timer join 10-100
no set garp timer join
The no version of this command sets the GVRP join time per port and per GARP to 20
centiseconds (0.2 seconds). This command has an effect only when GVRP is enabled.
Default
20 centiseconds
Mode
Interface Config, Global Config; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
set garp timer leave
This command sets the GVRP leave time per port. Leave time is the time to wait after
receiving an unregister request for a VLAN or a multicast group before deleting the VLAN
entry. This can be considered a buffer time for another station to assert registration for the
same attribute in order to maintain uninterrupted service.time is 20 to 600 (centiseconds). The
value 60 centiseconds is 0.6 seconds.
Syntax
set garp timer leave 20-600
Use no set garp timer leave to set the GVRP leave time per port to 60 centiseconds (0.6
seconds).
Default
60
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)#
prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
Note: This command has an effect only when GVRP is enabled.
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode