Filter
Top Products
144 System Configuration Commands
ping
ping
This command checks if another computer is on the network and listens for connections. To
use this command, configure the switch for network (in-band) connection. The source and
target devices must have the ping utility enabled and running on top of TCP/IP. The switch
can be pinged from any IP workstation with which the switch is connected through the default
VLAN (VLAN 1), as long as there is a physical path between the switch and the workstation.
The terminal interface sends three pings to the target station.
Syntax
ping ipaddr
Mode
Privileged Exec and User Exec
reload
This command resets the switch without powering it off. Reset means that all network
connections are terminated and the boot code executes. The switch uses the stored
configuration to initialize the switch. You are prompted to confirm that the reset should
proceed. A successful reset is indicated by the LEDs on the switch.
Syntax
reload
Mode
Privileged Exec
Usage
Information
For a sample of the output from the reload command, see the section “Upgrading the
Software Image” in the Getting Started chapter of the book SFTOS Command Reference
Guide.
show terminal length
This command displays how many lines are currently in one page of “show” command
output, as configured by the
terminal length command.
Syntax
show terminal length
Mode
Privileged Exec and User Exec
Command
History
Version 2.3 Introduced
Related
Commands
terminal length Sets the number of lines displayed on the terminal without pausing.