Filter
Top Products
set igmp maxresponse (global)
SFTOS Command Reference for the S2410, Version 2.4.1.0 243
Related
Commands
set igmp maxresponse (global)
This command sets the IGMP maximum response time on the system.
Syntax
[no] set igmp maxresponse 1-3599
The variable is the amount of time in seconds that a switch will wait after sending a query on
an interface because it did not receive a report for a particular group in that interface. This
value must be less than the IGMP Query Interval time value. The range is 1 to 3599 seconds.
The
no set igmp maxresponse command sets the IGMP Maximum Response time on the
system to 10 seconds.
Default
10
Mode
Global Config
Related
Commands
set igmp maxresponse (interface)
Command
History
Related
Commands
igmp interfacemode enable all Sets the IGMP Group Membership Interval time on a
particular interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.
show igmpsnooping Displays IGMP Snooping status information.
Version 2.3
Revised to
igmp maxresponse.
igmp maxresponse Sets the IGMP Maximum Response time on a particular interface.
igmp enable (interface) Enables IGMP Snooping on a selected interface.