Filter
Top Products
210 DHCP Server Commands
network
network
This command is used to configure the subnet number and mask for a DHCP address pool on
the server. Network-number is a valid IP address, made up of four decimal bytes ranging from
0 to 255. IP address 0.0.0.0 is invalid. Mask is the IP subnet mask for the specified address
pool. The prefix-length is an integer from 0 to 32.
The
no version of this command removes the subnet number and mask.
Syntax
network networknumber [mask | prefixlength]
no network
Default
none
Mode
DHCP Pool Config
netbios-name-server
This command configures Windows Internet Naming Service (WINS) name servers that are
available to DHCP clients. WINS name servers map NetBIOS names to IP addresses on TCP/
IP networks.
One IP address is required, although one can specify up to eight addresses in one command
line. Servers are listed in order of preference (
address1 is the most preferred server,
address2 is the next most preferred server, and so on).
Syntax
[no] netbios-name-server address [address2...address8]
Default
none
Mode
DHCP Pool Config
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients. The
type variable specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
•m-node—Mixed