Filter
Top Products
classofservice trust
SFTOS Command Reference for the S2410, Version 2.4.1.0 277
Command
History
classofservice trust
This command sets the class of service trust mode of an interface to Dot1p (802.1p). (The
ip-precedence and ip-dscp options, for IP Precedence and IP DSCP packet markings, are not
available in SFTOS 2.4.1.)
Syntax
classofservice trust dot1p
The no classofservice trust command sets the interface mode to untrusted.
Modes
Global Config; Interface Config; Interface Range, which is indicated by the
(conf-if-range-
interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
cos-queue max-bandwidth
This command specifies the maximum transmission bandwidth limit for each interface queue.
Also known as rate shaping, this has the effect of smoothing temporary traffic bursts over
time so that the transmitted traffic rate is bounded. The total number of queues supported per
interface is platform-specific (four queues in the S2410).
Syntax
[no] cos-queue max-bandwidth bw-0…bw-3
For the variable, bw represents bandwidth, and the suffix number represents one of the four
S2410 queues. For example, enter 40-3 for a maximum bandwidth of 40% in queue 3.
Version 2.3 Interface Range mode added
Related
Commands
classofservice
dot1pmapping
Maps an 802.1p priority to an internal traffic class.
interface range Defines an interface range and accesses the Interface Range mode
show classofservice
dot1p-mapping
Displays the current Dot1p (802.1p) priority mapping to internal traffic
classes for a specific interface
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode