Filter
Top Products
radius accounting mode
SFTOS Command Reference for the S2410, Version 2.4.1.0 181
radius accounting mode
This command is used to enable the RADIUS accounting function.
The
no version of this command is used to set the RADIUS accounting function to the default
value - i.e. the RADIUS accounting function is disabled.
Syntax
radius accounting mode
Default
disabled
Mode
Global Config
radius server host
Configure the RADIUS authentication and accounting server connections.
Syntax
radius server host {auth | acct} ipaddr [port]
no radius server host {auth | acct} ipaddr
Usage
If the auth keyword is used, the command configures the IP address to use to connect to a
RADIUS authentication server. Up to 3 servers can be configured per RADIUS client. If the
maximum number of configured servers is reached, the command will fail until one of the
servers is removed by executing the
no form of the command.
If the optional
port parameter is used with the auth keyword, the command will configure
the UDP port number to use to connect to the configured RADIUS authentication server. In
order to configure the UDP port number, the IP address must match that of a previously
configured RADIUS authentication server. The port number must lie between 1 - 65535, with
1812 being the default value.
Parameters
auth
Use this keyword if you want to configure a connection to a RADIUS
authentication server. See Usage, below.
acct
Use this keyword if you want to configure a connection to a RADIUS
accounting server. See Usage, below.
ip-addr
Enter the IP address, in dotted decimal format, of the server host.
port
(Optional) Configure the UDP port number to use to connect to the configured
RADIUS server. See Usage, below.