Filter
Top Products
94 System Management Commands
show serial
SNMP Management Commands
This section describes the SNMP system management commands supported by SFTOS:
• show snmpcommunity on page 95
• show snmptrap on page 95
• show trapflags on page 96
• snmp-server on page 97
• snmp-server community on page 97
• no snmp-server community on page 97
• snmp-server community ipaddr on page 98
• snmp-server community ipmask on page 98
• snmp-server community mode on page 98
• snmp-server community ro on page 99
• snmp-server community rw on page 99
• snmp-server enable traps bcaststorm on page 99
• snmp-server enable traps linkmode on page 100
• snmp-server enable traps multiusers on page 100
• snmp-server enable traps stpmode on page 101
• snmp-server enable trap violation on page 101
• snmp-server traps enable on page 101
• snmptrap on page 102
• snmptrap ipaddr on page 102
• snmptrap mode on page 102
• snmp trap link-status on page 103
• snmp trap link-status all on page 103
• snmptrap snmpversion on page 103
For information on configuring SNMP, see the Management chapter in the
SFTOS
Configuration Guide
.
Note: The Layer 3 Routing Package of SFTOS also contains these SNMP traps:
In Global Config mode:
•[no] ip dvmrp trapflags: Sets the DVMRP (Distance Vector Multicast Routing Protocol)
traps flag (disabled by default). See the Multicast chapter.
•[
no] ip pim-trapflags: Sets the PIM traps flag (disabled by default). See the PIM
chapter.
In Router OSPF Config mode:
•[no] trapflags: Sets the OSPF traps flag. See the OSPF chapter (enabled by default).