Filter
Top Products
snmp trap link-status
SFTOS Command Reference for the S2410, Version 2.4.1.0 103
snmp trap link-status
This command enables link status traps by interface.
Syntax
[no] snmp trap link-status
The no version of this command disables link status traps by interface.
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)#
prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
snmp trap link-status all
This command enables link status traps for all interfaces.
Syntax
[no] snmp trap link-status all
The no version of this command disables link status traps for all interfaces.
Mode
Global Config
snmptrap snmpversion
This command selects between SNMP version 1 and version 2 traps to be sent for the selected
SNMP trap name.
Syntax
snmptrap snmpversion name ipaddr {snmpv1|snmpv2}
Mode
Global Config
Note: This command is valid only when the Link Up/Down Flag is enabled. See
snmp-server enable traps linkmode command.
Version 2.3 Added Interface Range mode.
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode
interface Identifies an interface and enters the Interface Config mode.
Note: This command is valid only when the Link Up/Down Flag is enabled. See
snmp-server enable traps linkmode.