Filter
Top Products
272 Spanning Tree (STP) Commands
spanning-tree mst vlan
If 0 (defined as the default CIST ID) is passed as the mstid, then this command sets the
Bridge Priority parameter for the common and internal spanning tree to the default value, in
other words, 32768.
Syntax
spanning-tree mst priority mstid 0-61440
no spanning-tree mst priority mstid
Default
32768
Mode
Global Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt,
such as (conf-if-range-vlan 10-20)#.
Command
History
spanning-tree mst vlan
This command adds an association between a multiple spanning tree instance and a VLAN.
The VLAN will no longer be associated with the common and internal spanning tree. The
instance
mstid is a number that corresponds to the desired existing multiple spanning tree
instance. The
vlanid corresponds to an existing VLAN ID.
The
no version of this command removes an association between a multiple spanning tree
instance and a VLAN. The VLAN will again be associated with the common and internal
spanning tree. The instance
mstid is a number that corresponds to the desired existing
multiple spanning tree instance. The
vlanid corresponds to an existing VLAN ID.
Syntax
spanning-tree mst vlan mstid vlanid
no spanning-tree mst vlan mstid vlanid
Mode
Global Config
spanning-tree port mode enable
This command sets the Administrative Switch Port State for this port to enabled.
The
no version of this command sets the Administrative Switch Port State for this port to
disabled.
Version 2.3 Added Interface Range mode.
Related
Commands
interface Identifies an interface and enters the Interface Config mode.
interface range Defines an interface range and accesses the Interface Range mode