Filter
Top Products
spanning-tree edgeport
SFTOS Command Reference for the S2410, Version 2.4.1.0 267
The no version of this command sets the Configuration Identifier Revision Level for use in
identifying the configuration that this switch is currently using to the default value, in other
words, 0.
Syntax
spanning-tree configuration revision 0-65535
Default
0
Mode
Global Config
spanning-tree edgeport
This command specifies that this port is an edge port (portfast) within the common and
internal spanning tree. This will allow this port to transition to forwarding state without delay.
The
no version of this command specifies that this port is not an Edge Port within the
common and internal spanning tree.
Syntax
[no] spanning-tree edgeport
Mode
Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)#
prompt, such as (conf-if-range-vlan 10-20)#.
Command
History
spanning-tree forceversion
This command sets the Force Protocol Version parameter to a new value. The Force Protocol
Version can be one of the following:
• 802.1d - STP BPDUs are transmitted rather than MST BPDUs (IEEE 802.1D
functionality supported)
• 802.1w - RST BPDUs are transmitted rather than MST BPDUs (IEEE 802.1w
functionality supported)
• 802.1s - MST BPDUs are transmitted (IEEE 802.1s functionality supported)
The
no version of this command sets the Force Protocol Version parameter to the default
value, in other words, 802.1s.
Version 2.3 Added Interface Range mode.
Related
Commands
interface Identifies an interface and enters the Interface Config mode.
interface range Defines an interface range and accesses the Interface Range mode