Filter
Top Products
38 Quick Start
Downloading from a TFTP Server
1. Before starting a TFTP server download, configure the management IP address of the
switch; see Management IP Address on page 35.
2. To download from a TFTP server, use the
following command:
Using Factory Defaults
To load factory defaults, use either of the following commands:
Command Syntax Command Mode Purpose
copy tftp://ip address/
{nvram:startup-config |
system:image}
(See copy on page 139.)
Privileged Exec Set the destination (download) datatype:
For the SFTOS software image, use system:image.
For a configuration file, use
nvram:startup-config.
The URL is specified as:
tftp://ipAddr/filepath (where filepath
includes the filename, such as S2410/2410software.bin)
Command Syntax Command Mode Purpose
clear config
Privileged Exec
Enter
y at the prompt that asks if you want to clear all the
configurations made to the switch.
reload (or cold boot of the switch)
Privileged Exec Alternatively, use this command to restart the system and
access the Boot menu, where you can select an option to load
factory defaults. See Using the Boot Menu on page 32.
Enter
y at the prompt that asks if you want to reset the system.
Choose to reset the switch or cold boot the switch—both work
effectively.