Filter
Top Products
174 Security Commands
dot1x system-auth-control
Command
History
dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default,
the authentication support is disabled. While disabled, the dot1x configuration is retained and
can be changed, but is not activated.
The
no version of this command is used to disable the dot1x authentication support on the
switch.
Syntax
dot1x system-auth-control
Default
disabled
Mode
Global Config
dot1x timeout
This command sets the value, in seconds, of the timer used by the authenticator state machine
on this port. Depending on the keyword used and the value (in seconds) passed, various
timeout configurable parameters are set.
Syntax
dot1x timeout {{reauth-period seconds} | {quiet-period seconds} | {tx-period
seconds} | {supp-timeout seconds} | {server-timeout seconds}}
The no version of this command sets the value, in seconds, of the specified timer to the its
default value:
no dot1x timeout {reauth-period | quiet-period | tx-period | supp-timeout |
server-timeout}
Parameters reauth-period—Sets the value, in seconds, of the timer used by the authenticator state machine on this
port to determine when re-authentication of the supplicant takes place. The reauth-period must be a
value in the range 1 - 65535.
quiet-period—Sets the value, in seconds, of the timer used by the authenticator state machine on this
port to define periods of time in which it will not attempt to acquire a supplicant. The quiet-period must
be a value in the range 0 - 65535.
Version 2.3 Interface Range mode added
Related
Commands
interface range Defines an interface range and accesses the Interface Range mode