Filter
Top Products
98 System Management Commands
snmp-server community ipaddr
snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet-sending address and is used along with the client IP mask value to
denote a range of IP addresses from which SNMP clients may use that community to access
the device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is
ANDed with the mask to determine the range of allowed client IP addresses. The name is the
applicable community name.
Syntax
snmp-server community ipaddr ipaddr name
Use no snmp-server community ipaddr name to reset a client IP address for an SNMP
community to 0.0.0.0. The name is the applicable community name.
Default
0.0.0.0
Mode
Global Config
snmp-server community ipmask
This command sets a client IP mask for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP address value
to denote a range of IP addresses from which SNMP clients may use that community to
access the device. A value of 255.255.255.255 will allow access from only one station, and
will use that machine's IP address for the client IP Address. A value of 0.0.0.0 will allow
access from any IP address. The name is the applicable community name.
Syntax
snmp-server community ipmask ipmask name
Use no snmp-server community ipmask name to reset a client IP mask for an SNMP
community to 0.0.0.0. The name is the applicable community name. The community name
may be up to 16 alphanumeric characters.
Default
0.0.0.0
Mode
Global Config
snmp-server community mode
This command activates an SNMP community. If a community is enabled, an SNMP
manager associated with this community manages the switch according to its access right. If
the community is disabled, no SNMP requests using this community are accepted. In this
case, the SNMP manager associated with this community cannot manage the switch until the