Filter
Top Products
hardware-address
SFTOS Command Reference for the S2410, Version 2.4.1.0 207
hardware-address
This command specifies the hardware address of a DHCP client.
The
hardware-address is the MAC address of the hardware platform of the client
consisting of 6 bytes in dotted hexadecimal format.
The
type indicates the protocol of the hardware platform. It is 1 for 10 MB Ethernet and 6 for
IEEE 802.
The
no version of this command removes the hardware address of the DHCP client.
Syntax
[no] hardware-address hardware-address [type]
Default
ethernet
Mode
DHCP Pool Config
host
This command specifies the IP address and network mask for a manual binding to a DHCP
client. Address and Mask are valid IP addresses; each made up of four decimal bytes ranging
from 0 to 255. IP address 0.0.0.0 is invalid.
The prefix-length is an integer from 0 to 32.
The
no version of this command removes the IP address of the DHCP client.
Syntax
host address [mask | prefix-length]
no host
Default
none
Mode
DHCP Pool Config