Filter
Top Products
78 System Management Commands
show logging
Usage
Information
The following example shows sample output of the show interfaces description
command with an interface specified in the unit/slot/port form:
Example
Figure 12 Output of the show interfaces description Command
Related
Commands
show logging
Related
Commands
show mac-addr-table
This command displays the forwarding database entries. If the command is entered with no
parameter, the entire table is displayed. the same as entering the optional
all parameter.
Alternatively, you can enter a MAC address to display the table entry for that address and all
entries following it.
Syntax
show mac-addr-table [macaddr | all] [interface unit/slot/port | vlan VLAN_ID |
count
]
Force10#show interfaces description 1/0/1
Interface.......1/0/1
IfIndex.........1
Description.....1/0/1 is access port
MAC Address.....00:01:E8:D5:BA:C0
Bit Offset Val..1
description User-entered description of the selected interface
show interfaces cos-queue The class-of-service queue configuration for the specified interface
show port The configuration and status of the specified interface or of all
interfaces
show port-channel The configuration and status of the specified LAG or of all LAGs
Note: See the various versions of the show logging command in the Syslog chapter
(System Log on page 149).
show logging Displays a combination of the system log and event log (buffered log).
show logging buffered Displays buffered logging (the System log)
show logging hosts Displays configured logging hosts (syslog servers.
show logging traplogs Displays trap summaries (number of traps since last reset and last
view) and trap details.