Filter
Top Products
Service Tests and Utilities
4-4
HP DesignJet 5000 Series Printers Service Manual
Spinning up disk Boot Failed:1f500XX
This is an error related
to the Hard Disk
Drive, either the
connections are bad or
the Hard Disk Drive or
the Main PCA are
defective.
n Unplug the Printer, remove the HDD
cover and check that the two cables (a
flat one and the power cable) are
connected. Also check that the flat
cable connector is clipped in correctly.
If the problem persists, replace the Hard
Disk Drive ⇒ Page 8-72.
n If the problem continues, check that the
Green and Orange LED’s on the Main
PCA are ON. If they are not ON,
probably the PWS or its connections are
defective. If the two LED’s are ON and
the error continues, replace the Main
PCA ⇒ Page 8-79.
Spinning up disk...OK
Loading
firmware.fmw
Boot FAILED
Download the Firmware file to the Printer
⇒ Page 9-12.
Initializing
Initializing L2C
Initializing CLK
Initializing IO
BOOTROM ERROR:
Current Version:XXX
Necessary
Vers io n:X XX
Replace and Restart
The BootROM version and the Firmware
version do not match. Download the
BootROM version indicated by the
"Necessary Version" message.
COMPONENT
MISMATCH:
You are running a
XXX printer with a
XXX disk
Insert XXX disk and
restart.
The Hard Disk Drive, or the Firmware on
the Hard Disk Drive, does not match the
BootROM Printer Model.
For RTL Printers (Part No. C6090A and
C6095A - see label on the Back Cover):
Make sure RTL Hard Disk Drives and
Firmware are used. For Part Numbers see
Page 7-1.
For Postscript Printers (Part No. C6091A
and C6096A - see label on the Back
Cover):
Make sure Postscript Hard Disk Drives and
Firmware are used. For Part Numbers see
Page 7-1.
Self Diagnostics - Initialization Sequence
LED’s Front Panel Message Printer Error - Error
Message/Code
Corrective Action
Max. Quality
Productivity
Max. Speed
Max. Quality
Productivity
Max. Speed
Max. Quality
Productivity
Max. Speed