Filter
Top Products
Removal and Installation
8-92
HP DesignJet 5000 Series Printers Service Manual
Electronics Module (as one complete Assembly)
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Left Rear Cover - Refer
to Page 8-15.
2. Remove the Right Rear Cover - Refer
to Page 8-16.
3. Disconnect ALL Cables from the
Main PCA (Right Rear Cover) and
ISS PCA (Left Rear Cover) and
remove the Ferrites from the left side.
4. Remove 2 T-15 screws (Type B) from
the both sides of the Electronics
Module.
5. Lift the Electronics Module up (to
clear it from the shoulder screws) and
remove from the Printer.
LEFT
RIGHT
1
1
2