Filter
Top Products
Service Calibrations
5-9
HP DesignJet 5000 Series Printers Service Manual
4. When you have inserted the Line Sensor Id. the message below is
displayed. Press Enter to confirm the number and continue the
calibration or Back to modify the number.
5. If you do not insert correct values the message below is displayed.
Press Enter to continue the calibration using default values.
NOTE If Scan Axis Calibration is performed without inserting the
correct Line Sensor Id., each time the user performs a Color
Calibration, a continuable Sytem Error will be reported - See
Chapter 2, System Error Codes.
6. Once the media is detected, the Calibration starts and the following
message is displayed:
During this stage the Printer will print the following pattern.
Top
Enter
Back
↑
↓
Make Selection
Press ENTER to confirm
or BACK to correct
Line Sensor Id:
08
Line Sensor
Top
Enter
Back
↑
↓
This Firmware Revision
does not support
the selected Line Sensor Id.
Press ENTER to continue
Press Enter
Line Sensor
Calibrating...