Filter
Top Products
Service Calibrations
5-27
HP DesignJet 5000 Series Printers Service Manual
Calibration Error: 0000
NOTE This code is not an error. See the other codes reported.
Calibration Error: 0001
Problem
Description:
Pen voltage error.
Corrective Action: Try the following:
n Power the Printer OFF and ON again using the Power Switch at
the back of the Printer and if a (XXXX)Replace message for a
particular Printhead is displayed, replace that Printhead.
n If the (XXXX)Replace message is for all Printheads, replace the
Carriage Assembly ⇒ Page 8-46.
Calibration Error: 0002
Problem
Description:
Line sensor could not calibrate.
Corrective Action: Check the media used for the Calibration is WHITE.
Try the following:
n Replace the Lens Cover Assembly ⇒ Page 9-5.
n Replace the Carriage Assembly ⇒ Page 8-46.
Calibration Error: 0003
Problem
Description:
Line sensor could not calibrate.
Corrective Action: Check the media used for the Calibration is WHITE.
Try the following:
n Replace the Lens Cover Assembly ⇒ Page 9-5.
n Replace the Carriage Assembly ⇒ Page 8-46.