Filter
Top Products
Removal and Installation
8-79
HP DesignJet 5000 Series Printers Service Manual
Main PCA
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the LAN Card - Refer to
Page 8-74.
2. Remove the Left Rear Cover - Refer
to Page 8-15.
3. Remove the Right Rear Cover - Refer
to Page 8-16.
4. Remove the Electronics Module
Cover - Refer to Page 8-77.
5. Disconnect and remove the Hard Disk
Drive for safety reasons - Refer to
Page 8-72.
6. Remove ALL BootROM/Memory
DIMM’s - Refer to Page 8-75.
7. Disconnect ALL Cables from the
Electronics Module (see Installation
of Main PCA for connections).
8. Remove 2 T-10 screws (Type K) to
remove the HDD controller.