Filter
Top Products
Service Tests and Utilities
4-31
HP DesignJet 5000 Series Printers Service Manual
Backup EEROM
This Service Utility is used to restore the contents of the EEROM
when a service engineer has replaced the Main PCA or the Hard
Disk Drive. If the Main PCA is replaced the EEROM content,
backed up on the hard disk, is restored to the Main PCA and if the
Hard Disk Drive is replaced the EEROM content is saved to the new
Hard Disk Drive.
WARNING Before using this utility, make sure that you are using Firmware
version A.02.xx. If NOT, make sure that you upgrade the
Firmware version to A.02.xx BEFORE using this utility.
NOTE If both the Hard Disk Drive and the Main PCA are replaced, on
Printer start-up a continuable system error is displayed and you
must perform all ALL the Calibrations as well as the EEROM
Setup Service Utility (See Page 4-24).
1. In the Service Utilities submenu, scroll to "1.6 Backup EEROM"
and press Enter.
2. Select the part that has been replaced and press Enter:
1. Service Utilities
1.3 Altitude Setup
1.2 Prime TUBES
1.4 EEROM Setup
1.5 Reset Life Counters
1.6 Backup EEROM
Top
Enter
Back
↑
↓
Press Enter
Make Selection
1.1 Turn DRIVE ROLLER
1.6 Backup EEROM
Top
Enter
Back
↑
↓
Press Enter
Make Selection
Main PCA
Hard Disk Drive (HDD)