Filter
Top Products
Preventive Maintenance
9-3
HP DesignJet 5000 Series Printers Service Manual
Warning/Stop Triggers
NOTE If the Ink Tubes System needs to be replaced, this can be
performed by the User.
The Printer will advise the User when the Carriage and/or Tubes
need to be replaced by displaying a Warning message. The Warning
message is triggered by the following number of cycles:
n 6.5 million for the Carriage.
n 6.5 million for the Tubes.
The number of cycles can be checked at anytime by printing the
Service Configuration Print.
NOTE Remember to perform the Reset Life Counters Service Utility
(Refer to ⇒ Page 4-29), to set the usage cycles to zero for the
worn parts replaced with parts from the Service Preventive
Maintenance Kit. Service preventive maintenance messages will
not disappear until the counter is reset for the part replaced.
"Printer Maintenance Advised"
If BOTH the Carriage and the Ink Tubes have done more than 6.5
million cycles, then this message will appear on the Front Panel. In
this case, you must replace BOTH the Service Preventive
Maintenance Kit and the Ink Tubes System (either Dye or UV,
depending on which ink system the User has installed).
"(3) Printer Maintenance Advised"
If ONLY the Carriage has done more than 6.5 million cycles, then
this message will appear on the Front Panel. In this case, you must
replace Only the Service Preventive Maintenance Kit.
"Ink Tube Maintenance Advised"
If ONLY the Ink Tubes have done more than 6.5 million cycles,
then this message will appear on the Front Panel. In this case, you
must replace ONLY the Ink Tubes System (either Dye or UV,
depending on which ink system the User has installed).