Filter
Top Products
System Error Codes
2-18
HP DesignJet 5000 Series Printers Service Manual
System Error: 0B000A
Problem
Description:
Primer Shutdown Error.
Corrective Action: Try the following:
n Check that the Service Station Cable (the grey flat cable with the
grey connector) is plugged into the Main PCA, and that the clips
of the connector are closed. Also check that the cable is not
damaged.
n Replace the Service Station ⇒ Page 8-67.
System Error: 0B000B
Problem
Description:
APS Failure.
Corrective Action: Try the following:
n Check that the cable from the Ink Supply Station (ISS) PCA to
the Ink Supply Station is correctly connected.
n Check that the Air Pressurization System Sensor Cable is
correctly connected and is NOT damaged.
n Check all the tubes of the APS and make sure they are NOT
pinched or damaged.
n Faulty APS. Replace the APS ⇒ Page 8-65.
n If the error code continues, replace the Main PCA ⇒ Page 8-79.
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed.
System Error: 0B000C
Problem
Description:
Serial Device ADC test failure.
Corrective Action: Replace the Main PCA ⇒ Page 8-79.