Removal and Installation
8-10
HP DesignJet 5000 Series Printers Service Manual
Right Hand Cover
Removal
WARNING Switch off the Printer and remove the Power Cord.
WARNING To remove the Right Hand Cover you must open the Right Cover
door and push in the Printhead Cleaner Carriage.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Right Rear Cover - Refer
to Page 8-16.
2. Remove the Ferrite and disconnect the
Front Panel cable from the Main PCA
(P24) from the left side of the
Electronics Module.
3. On the Main PCA, disconnect the
Aerosol Fan cable from position P30
and the service station door from
position P29.
P24
P29
P30