Filter
Top Products
Removal and Installation
8-107
HP DesignJet 5000 Series Printers Service Manual
Center Guide Assembly
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the Top Cover - Refer to
Page 8-5.
2. Remove the Back Cover - Refer to
Page 8-23.
3. Remove the Lower Right EMC Cover
- Refer to Page 8-32.
4. Remove Right Rear Cover - Refer to
Page 8-16.
5. Remove Left Rear Cover - Refer to
Page 8-15.
6. Remove the Deflectors - Refer to Page
8-114.
7. Remove the Left Hand Cover - Refer
to Page 8-6.
8. Remove the Right Hand Cover - Refer
to Page 8-10.
9. Remove the Left Hand Trim - Refer to
Page 8-22.
10. Remove the Right Hand Trim - Refer
to Page 8-20.
11. Remove the Media Lever Assembly -
Refer to Page 8-18.
12. Remove the ISS - Refer to Page 8-62.
13. Remove the Service Station - Refer to
Page 8-67.
14. Remove the Vacuum Fan - Refer to
Page 8-98.
15. Remove the Electronics Module -
Refer to Page 8-92.