Filter
Top Products
Service Calibrations
5-8
HP DesignJet 5000 Series Printers Service Manual
If the Media loaded is not the right size, the following message is
displayed. Press Enter to exit. Load the correct media and repeat
the procedure.
2. If the correct media is loaded, the following message is displayed.
Press Enter to confirm or Back to return to the Service Calibrations
menu.
3. When the following message is displayed, you will need to enter the
Line Sensor id.
NOTE The Line Sensor Id. is a two digit figure in a 01 - 99 range which
can be located on the label on the side of the Line Sensor
Assembly on the right side of the Carriage.
To insert a number use the UP and DOWN keys to scroll through a
list of characters in the following ranges: 1...9 and (Backspace)
to delete a character previously confirmed using the Enter key.
After selecting the first digit, press Enter to insert the second digit.
Press Enter to continue when both digits have been entered.
n If the Line Sensor ID is not indicated on the Line Sensor, use the
default value which is "0". In the future, if the LED’s are
modified, a sticker will be included with the new Line Sensor ID.
2.1 Scan Axis
Top
Enter
Back
↑
↓
Press ENTER to continue
Media too small.
Remove Media.
Press Enter
2.1 Scan Axis
Top
Enter
Back
↑
↓
Press ENTER to confirm or
BACK to correct
Make Selection
Line Sensor
Top
Enter
Back
↑
↓
Make Selection
Press Enter
Line Sensor Id:_ _
Use Up / Down buttons
to scroll