Filter
Top Products
Removal and Installation
8-32
HP DesignJet 5000 Series Printers Service Manual
EMC Covers
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
NOTE The EMC Cover is composed of three parts; Top, Lower Left and
Lower Right. Procedures below describe removal of the EMC
Covers as; one assembly, the Top only, the Lower Right only. The
procedure you select depends on the part you want to access.
EMC Covers as one assembly
1. Remove the Top Cover - Refer to
Page 8-5.
2. Remove the Back Cover - Refer to
Page 8-23.
3. Remove Right Rear Cover - Refer to
Page 8-16.
4. Remove Left Rear Cover - Refer to
Page 8-15.
5. Remove Electronics Module - Refer
to Page 8-92.
6. Disconnect connector from Ink Leak
Detector and remove 1 T-15 screw
(Type B) to remove Ink Leak Detector
cable clamp.