Removal and Installation
8-83
HP DesignJet 5000 Series Printers Service Manual
Power Supply Unit (PSU)
Removal
WARNING Switch off the Printer and remove the Power Cord.
NOTE Refer to the table on Page 8-4 for information on screw types.
1. Remove the LAN Card - Refer to
Page 8-74.
2. Remove the Left Rear Cover - Refer
to Page 8-15.
3. Remove the Right Rear Cover - Refer
to Page 8-16.
4. Remove the Electronics Module
Cover - Refer to Page 8-77.
5. Disconnect and remove the Hard Disk
Drive for safety reasons - Refer to
Page 8-72.
6. Disconnect the PCA Power Supply
connector from the Main PCA.
PCA PS Connector